A Guide To P&L Plumbing

Usual home repair work is to install a water heater. It is not a complex process, and the construction can be completed by homeowners themselves. Nonetheless, ascertaining that there is no space for errors is crucial. To stop negative effects, it is necessary to read the instructions and obey only a few simple guidelines. Below are some steps that can help you to perfectly install the water heaters.

The first step to install a new water heater is to unbundle the old one. Turn the water, electricity or gas supply off before disconnecting the old unit. To remove hot water, use a wrench to screw off the inlet and outlet fittings if necessary. For gas heaters, the vent pipe which is attached to the draft hood must be removed. Remove the flue hat from the heater top, as well.Have a look at P&L Plumbing for more info on this.

Water heaters are extremely heavy. Therefore it is preferable to use a dolly while shifting the device to avoid damage.

Position the new unit in such a way that the connecting pipes and controls are easily accessible. Make sure gas water heaters are tightly attached to keep the gas from escaping. Maintain 6 inches of open area around the perimeter. Please make sure no flammable materials are in the area.

Screw the blue inlet and outlet fittings into the cold water inlet, and red into the hot water outlet. Please make sure the arrowheads on the valves point in the direction of flowing water. Next the third line is connected to the main water source drain.

Connect versatile inlet and outlet connections to the tubing. Install a shut-off valve into the inlet of cold water. Switch on the relief valve that regulates the produced heat and air pressure in the water heater.

The final step after completing all the connections is to link the new water heater to the power supply. For proper electrical connections please refer to the manual.

Open the shut-off valve that fills the radiator with gas. Open the hot water faucets while it is flowing, to expel air from the tubing.